Butterfly valve vs gate valve vs ball valve: which is better?
Use a butterfly valve for large water and air lines, a gate (sluice) valve where the bore must be fully clear, and a ball valve for small lines that need a quick, tight shut-off.
Read the guideSluice valve vs gate valve: what is the difference?
There is no difference in principle: a sluice valve is a gate valve for water works. In India the name usually means a cast or ductile iron valve made to IS 14846.
Read the guidePN 10 vs PN 16: what does PN 16 mean?
PN 16 means a nominal pressure of 16 bar at 20 °C, about 232 psi; PN 10 means 10 bar, about 145 psi. The number also fixes which flange drilling a valve or flange matches.
Read the guideDN to inch to mm: valve and pipe size chart
DN is the nominal size in millimetres; inches (NPS) is the same size in the American system. DN 15 is ½ inch, DN 50 is 2 inches, DN 100 is 4 inches and DN 150 is 6 inches.
Read the guideWafer vs lug type butterfly valve: the difference
A wafer butterfly valve is clamped between two flanges by long through-bolts; a lug valve has threaded lugs, so each flange bolts to it on its own and one side can be removed while the other stays under pressure.
Read the guideButterfly valve seat materials: EPDM vs nitrile vs Viton vs PTFE
Choose EPDM for water, nitrile for oils and fuels, Viton (FKM) for hotter and more aggressive chemicals, and PTFE for the widest chemical resistance. Confirm the exact temperature limit on the valve maker's datasheet.
Read the guideCamlock coupling types and size chart
Camlock couplings come in types A, B, C, D, E and F, plus a dust cap and a dust plug. Any male adapter mates with any female coupler of the same size; the letter describes only the other end.
Read the guideDWC pipe sizes in mm, and SN 4 vs SN 8
DWC pipes are named by outside diameter in millimetres, made in sizes from about 75 to 800 mm, and rated SN 4 or SN 8: SN 8 is twice as stiff and goes under deeper cover or heavier traffic.
Read the guideCPVC vs uPVC: which is better?
CPVC is better for hot water, because it is made for hot and cold service; uPVC is better value for cold water, drainage and many chemical lines at ambient temperature.
Read the guideRubber bellow vs metallic bellow: which expansion joint?
A rubber bellow suits water, sewage and pump connections at moderate temperatures and absorbs vibration best; a metallic bellow suits steam, hot oil and high temperatures and pressures.
Read the guideIS 13095: the butterfly valve standard and BIS certification
IS 13095 is the Indian Standard for butterfly valves for general purposes. Under the Butterfly Valves (Quality Control) Order, 2020, the valves it covers must carry the BIS Standard Mark under a BIS licence from 01-Jan-2021.
Read the guide
A size or rating not listed?
Our procurement desk sources it, from Valvetech or anywhere in the world.