Guide

Wafer vs lug type butterfly valve: the difference

A wafer butterfly valve is clamped between two flanges by long through-bolts; a lug valve has threaded lugs, so each flange bolts to it on its own and one side can be removed while the other stays under pressure.

Published · Updated

The disc, the seat and the shaft are often identical. The difference is in the body, and it decides what you can do when the line is opened for maintenance.

WaferLug
BoltingThrough-bolts span both flangesEach flange bolts into threaded lugs
Cost and weightLowerHigher
Dead-end serviceNoYes, at the pressure its maker allows
Removing pipe on one sideLine must be drainedPossible with the other side live

Can a wafer valve be used at the end of a line?

No. With one flange removed, nothing holds it. Use a lug or double-flanged valve.

Installing a wafer valve

  1. Check the flange drilling matches the valve (PN 10, PN 16 or Table E).
  2. Set the disc slightly open so it does not catch the flange or pipe bore.
  3. Centre the body between the flanges; use no extra gasket where the seat seals the flange face.
  4. Tighten bolts evenly in a cross pattern, then open and close fully to check the disc clears.

On horizontal lines carrying solids, mount the shaft horizontally so grit does not settle in the lower bearing.

Need it quoted?

Send your BOQ, drawing or list of sizes through Request a quote. One quotation for the complete line.

Ranges in this guide:Butterfly valves

A size or rating not listed?

Our procurement desk sources it, from Valvetech or anywhere in the world.